HappyModel CrazyBee X F4 AIO Whoop Flight Controller (F4 FC, 5A 1-2S 4in1 ESC, 25mW VTX) - FrSky

  • Sale
  • $48.99


Flight controller, 4in1 ESC, VTX, and an RX all in one board. Just plug in or solder on your favorite camera and motors. This FC is very similar to the Crazybee F4 LITE but is capable of 1s OR 2s!

Specifications

F4 Flight Controller

  • MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
  • Sensor: MPU-6000(SPI connection)
  • Board size: 28.5 * 28.5MM
  • Power supply: 1S-2S battery input (DC 2.9V-8.7V)
  • Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
  • Built-in Betaflight OSD(SPI Control)
  • Built-in 5.8G VTX
  • Built-in SPI Frsky receiver support D8/D16
  • Built-in 5V 1A BEC
  • Built-in voltage detection
  • Firmware target: CRAZYBEEF4FR

Onboard 5A BL_S 4in1 ESC

  • Power supply: 1-2S LiPo/LiPo HV
  • Current: 5A continuous peak 6A (3 seconds)
  • Support BLHeliSuite programmable
  • Factory firmware: S_H_90_REV16_7.HEX
  • Default protocol: DSHOT600

Onboard SPI Frsky Receiver

  • SPI BUS receiver Frsky D8/D16 compatible
  • Support Frsky_X_LBT(EU-LBT), Fubata S-FHSS (Need Betaflight 4.0.5 firmware or latest)
  • Channels: 8ch/16ch
  • Failsafe support
  • No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m

Onboard 5.8G 40CH 25mW VTX

  • Output power: 25mw
  • Frequency: 40CH
  • Input voltage: 3.3V 5.5V
  • Current consumption: 300mA(type)
  • Frequency: 5.8GHz 5bands 40 channels
  • With Race band
  • Smartaudio ready
  • Default vtx_power should set to be “2”

Onboard Voltage and Current detector

  • Voltage Meter scale “110”
  • Amperage Mete scale “1175”

Includes

  • 1x HappyModel CrazyBee X F4 AIO Whoop Flight Controller (F4 FC, 5A 4in1 ESC, 25mW VTX) - FrSky
  • Mounting Hardware
  • A free pigtail to solder to any camera, so you can plug in any camera!